Maintenance Schedule - Toro 30301TC Operator's Manual

2- & 4-wheel drive traction units

Hide thumbs Also See for 30301TC:

Operator's manual (36 pages)

Table Of Contents

Table of Contents

Minimum Recommended Maintenance Intervals

Maintenance Procedure

Lubricate all grease fittings

Inspect the air filter

Check battery level/cable

connections

Change the engine oil and filter

Inspect cooling system hoses

Check fan and alternator belt tension

Torque the wheel lug nuts

Service the air filter

Change the fuel filter

Inspect the fuel line and connections

Check the engine RPM (idle and full throttle)

Check the rear axle oil level (4-wheel drive)

Change hydraulic oil

Change hydraulic oil filter

Change rear axle oil (4-wheel drive)

Inspect engine timing belt (see note below)

Drain and clean the fuel tank

Pack the 2-wheel drive's rear axle bearings

Check rear wheel toe-in

Initial break in at 10 hours

Initial break in at 50 hours

Initial break in at 200 hours

Replace moving hoses

Replace safety switches

Flush the cooling the cooling system and replace fluid

NOTE: Replace the timing belt after every 1500 hours of operation or if worn, cracked, oil soaked or any

time the belt is removed or loosened.