Sd Card - Vimtag VT 361 Manual

SD Card

The SD Card section indicates whether you have an SD card in the camera
and whether it is enabled.
To use the SD card, place it into the slot on the back of the camera. If
•
the card does not go in all the way by pushing it with your finger, you
can use the edge of a paperclip to push it into place. It will not damage
the camera.
• If the camera does not recognize the SD card, remove the card and
unplug the camera. Put in the SD card and then plug in the camera.
The camera will reboot, and then it should be recognized.
The maximum size card for the camera is 32GB, which should be able to
record roughly 60 hours of video. At the end of the 60 hours, the card will
record over the oldest segments first. Keep in mind that the videos are
recorded in half hour chunks.
When you go to the SD card settings, the card should be enabled by default.
If not, click ON. The following fields display the card information:
• Status - Connectivity and capacity, which will depend on the size of
your SD card.
Usage - Amount of used space.
•
The following option buttons allow you to perform important actions on
the card:
Format is an option for formatting the card. Whenever you install a
•
new card, you will need to format the card. Formatting erases
everything on the card. After clicking Format, follow the prompts.
VIMTAG IP VT 361 SECURITY CAMERA
Page
28