Wrench; Plus Sign; Refresh Arrow; Hide - Vimtag VT 361 Manual

If there is a red circle to the left of the camera name, it means that the
•
camera is offline and is not accessible from a remote location.
If you are unable to confirm that the camera is working, see
•
Troubleshooting for the

Wrench

The Wrench icon will allow you to remove certain cameras that you have
set up in your account. When you click the Wrench icon, all the cameras in
the list will now have a red circle with a white minus sign through it.
To remove a camera, click its red circle.
•
• To refresh the list and remove all red circles, click the plus sign icon.
Note: Be careful with this setting, so you do not delete any cameras by
mistake! If you do, you can add cameras with the plus sign icon.

Plus Sign

To add another camera to your account, click the plus icon, located just to
the right of the Wrench icon. When you click the icon, a popup will appear
in the center of the screen. In that popup screen, you will be able to add
the input device ID of the new camera. Add the ID and follow the screen
prompts to add the new camera to your list.

Refresh Arrow

The refresh arrow will refresh the list of cameras on the left side of your
screen.

Hide

To streamline your screen and hid the camera list, click the
just below the bar of three icons. Click the icon again to display the camera
list.
VIMTAG IP VT 361 SECURITY CAMERA
Camera.
icon located
Page
21