Error Messages - Onkyo TX-NR1000 Instruction Manual

Troubleshooting —Continued

Error Messages

"Not available with Headphones use"
• Operation not allowed while a pair of headphones is con-
nected.
"Not available in this Sp Config"
• Doesn't work with the current speaker configuration.
"Only available with Dolby D"
• Can be used with only Dolby Digital.
"Not available with this signal"
• Doesn't work with the current listening mode.
"Not available with Muting"
• Operation not allowed because the TX-NR1000/
TX-NR5000E is currently muted.
"Not available in this Listening Mode"
• Doesn't work with the current listening mode.
"Not available with NET AUDIO use"
• Operation not possible with Net Audio selected for the
input source.
"Not available with Dolby Headphone Off"
• Doesn't work with the Dolby Headphone function off.
"Not available with Dolby Headphone On"
• Doesn't work with the Dolby Headphone function on.
"Not available with zone2 out in Line out"
• Operation not possible with "1-8.f. Zone 2 Out" set to
"Line Out."
"Not available with zone3 out in Line out"
• Operation not possible with "1-8.g. Zone 3 Out" set to
"Line Out."
Memory backup
The TX-NR1000/TX-NR5000E uses a battery-less memory backup system in order to retain radio presets and other
settings when it is unplugged or in the case of a power failure. Although no batteries are required, the TX-NR1000/
TX-NR5000E must be plugged into an AC outlet in order to charge the backup system.
(On other than USA, Canadian, and Australian models, the TX-NR1000/TX-NR5000E's POWER switch must be set to
ON in order to charge the backup system). Once it has been charged, the TX-NR1000/TX-NR5000E will retain the
settings for several weeks, although this depends on the environment and time will be shorter in humid climates.
The TX-NR1000/TX-NR5000E contains a microcomputer for signal processing and control functions. In very rare situ-
ations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event
that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.
To reset the TX-NR1000/TX-NR5000E to its factory defaults, turn it on and, while holding down the [VIDEO 1] button,
press the [STANDBY/ON] button. When the reset is complete, "CLEAR" appears on the display and the TX-NR1000/
TX-NR5000E enters Standby mode.
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit's
malfunction. Before you record important data, make sure that the material will be recorded correctly.
149