Onkyo TX-NR1000 Instruction Manual page 53

Connecting the Power/Basic Operations —Continued
MACRO
Scroll wheel
MODE
DIMMER
T V
INPUT
+
CH
ENTER
DISC
-
PREV
CH
DISPLAY
REC MAIN A
AUDIO SUBTITLE
SURR THX
REPEAT A-B SEARCH
PURE A DIRECT
CH SEL
REPEAT VIDEO
TEST TONE CH SEL
PLAYLIST ALBUM AR TIST
AUDIO SEL
CAPS DELETE LANGUAGE LOCATION
RC-557M
RC-558M
Using the Sleep Timer (remote controller only)
With the sleep timer you can set the TX-NR1000/
TX-NR5000E so that it automatically turns off after a
set period.
Press the scroll wheel, and then
Remote
press the [SLEEP] button repeat-
controller
edly to select the required sleep
time.
You can set the sleep time from 90 to 10
minutes in 10 minute increments.
The [SLEEP] indicator appears on the
SLEEP
display when the sleep timer has been
set, as shown. The specified sleep time
appears on the display for about five
seconds, then the previous display
reappears.
Note:
If you are using the remote zone (Zone 2
or 3), it will turn off at the same time as
the main zone.
To cancel the sleep timer, press the
[SLEEP] button repeatedly until the
[SLEEP] indicator disappears.
To check the remaining sleep time,
press the [SLEEP] button. Note that if
you press the [SLEEP] button while the
sleep time is being displayed, you'll
shorten the sleep time by 10 minutes.
ZONE 2
INPUT
SLEEP
SLEEP
VOL
MUTING
MAIN B RANDOM
ANGLE LAST M
ALL ST STEREO
MEMORY
DSP DSP
LEVEL–
MUSIC PHOTO
LEVEL- LEVEL+
LEVEL+
GENRE
L NIGHT Re-EQ
Temporarily Changing the Speaker Output
Levels (remote controller only)
To change the individual speaker volumes temporarily,
follow the procedure given below. Each channel can be
set between –12 and +12 decibels (between –15 and
+12 decibels for the subwoofer). Note that the speaker
volumes will return to the original settings when the
TX-NR1000/TX-NR5000E is put in the standby state.
1
Press the scroll wheel to enter the
AMP mode.
2
Press the [CH SEL] button and
select the desired speaker.
CH SEL
3
Press the [LEVEL –] or [LEVEL +]
button to adjust the volume level.
LEVEL- LEVEL+
Note:
You cannot select a speaker if it is set to "Not Used" in
the Speaker Configuration Sub-menu of the Speaker/
Output Setup Menu.
53