Resetting The Remote Controller; Using The Remote Controller With Radio Frequency (Rc-558M Only) - Onkyo TX-NR1000 Instruction Manual

Onkyo home stereo system owner's manual
Hide thumbs Also See for TX-NR1000:
Table of Contents

Advertisement

Other Settings for the Remote Controller —Continued

Resetting the Remote Controller

You can reset the remote controller to its default set-
tings.
1
Press and hold the [CUSTOM] but-
ton for more than three seconds.
CUSTOM
The remote controller enters Custom
mode.
2
Roll the scroll wheel to select
"SETUP," and then press the scroll
wheel.
3
Roll the scroll wheel to select
"RESET," and then press the scroll
wheel.
4
Roll the scroll wheel to select
"YES," and then press the scroll
wheel.
The remote controller is reset to its
default settings.
Using the Remote Controller with
Radio Frequency (RC-558M only)
You can set the remote controller's transmission signal
format to either infrared (IR) or radio frequency (RF).
The default setting is IR.
This is useful when, for example, the TX-NR1000/
TX-NR5000E is installed in a rack or is not in line of
sight of the remote controller as it allows you to use a
commercially available RF receiver to pick up com-
mands from the remote controller, which are then fed to
the TX-NR1000/TX-NR5000E via its IR IN socket. For
this to work, you must assign the same ID and channel
to the remote controller and RF receiver.
1
Press and hold the [CUSTOM] but-
ton for more than three seconds.
CUSTOM
The remote controller enters Custom
mode.
2
Roll the scroll wheel to select
"SETUP," and then press the scroll
wheel.
3
Roll the scroll wheel to select "IR/
RF," and then press the scroll
wheel.
4
Roll the scroll wheel to select "IR"
or "RF," and then press the scroll
wheel.
When you select "IR."
5
If you select "RF," roll the scroll
wheel to select the same ID as the
RF receiver, and then press the
scroll wheel.
IDs 0 to 9 and A to F can be selected.
6
Roll the scroll wheel to select the
same channel as the RF receiver,
and then press the scroll wheel.
Channels 0 to 3 can be selected.
If the ID and channel have been set suc-
cessfully, "OK" appears on the display.
141

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tx-nr5000e

Table of Contents