Error Messages - Onkyo TX-NR1007B Instruction Manual

User manual
Table of Contents

Advertisement

First Time Setup—Continued
9
When the calculations are com-
plete, the following screen
appears.
MultEQ XT: Auto Setup
Subwoofer
Front
Center
Surround
Front Wide
Front High
Surr Back
Surr Back Ch
Save
Cancel
Use the Up and Down [ ]/[ ] but-
tons to select an option, and then
press [ENTER].
The options are:
Save:
Save the calculated settings and exit
the room correction and speaker
setup.
Cancel:
Cancel the room correction and
speaker setup.
Note:
You can view the calculated settings for
the speaker configuration, speaker dis-
tances, and speaker levels by using the
Left and Right [ ]/[ ] buttons.
10
If you selected "Save", the results are
saved, and the following screen
appears.
MultEQ XT: Auto Setup
11
Disconnect the speaker setup
microphone.
MultEQ XT: Auto Setup
Please, unplug setup microphone.
Notes:
• When the room correction and speaker setup is
complete, the "Equalizer Settings" (page 93) will be
-- Review SP Configuration --
No
Full Band
40Hz
120Hz
Full Band
Full Band
150Hz
2ch
Saving...
set to "Audyssey" and "Dynamic EQ" (page 97) will
be set to "On".
• You can cancel the Room Correction and Speaker
Setup at any point in this procedure simply by
disconnecting the setup microphone.

Error Messages

While the room correction and speaker setup is in
progress, one of the following error messages may
appear:
❏ Ambient noise is too high.
MultEQ XT: Auto Setup
Ambient noise is too high.
Retry
Cancel
This message appears if the background noise is too
loud and the measurements cannot be performed
properly.
Remove the source of the noise and try again.
Retry: Return to the measured point immediately
before and start set up again.
Cancel: Cancel the room correction and speaker setup.
❏ Speaker Detect Error
This message appears if a speaker is not detected. "Yes"
means that a speaker was detected. "No" means that no
speaker was detected.
MultEQ XT: Auto Setup
Speaker Detect Error
FL
:
No
SL
:
---
FWL :
---
FHL :
---
SBL :
---
C
:
---
Retry
Cancel
The front speaker has not been detected.
FR
:
---
SR :
---
FWR :
---
FHR :
---
SBR :
---
SW1 :
---
SW2 :
---
59

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nr1007 - tx av network receiverTx-nr1007

Table of Contents