Onkyo TX-NR1000 Instruction Manual page 140

Other Settings for the Remote Controller —Continued
Deleting Remote Controller Modes
You can delete remote controller modes that you don't
need, such as modes for components that you don't have.
The AMP mode cannot be deleted.
1
Press and hold the [CUSTOM] but-
ton for more than three seconds.
CUSTOM
The remote controller enters Custom
mode.
2 Roll the scroll wheel to select
"MODE," and then press the scroll
wheel.
3 Roll the scroll wheel to select
"DEL," and then press the scroll
wheel.
4
Roll the scroll wheel to select the
mode you want to delete, and then
press the scroll wheel.
If the mode is deleted successfully, after
"OK" has been displayed, the DEL dis-
play (step 3) reappears.
140
Assigning Remote Controller Modes
You can change the combination in selecting the input
source and remote controller mode simultaneously
using the scroll wheel. For example, when the input
source (top) is "TAPE1" and the remote controller
mode (bottom) is "AMP," you can change only
"AMP"(the remote controller mode) to "CDR."
1
Press and hold the [CUSTOM] but-
ton for more than three seconds.
CUSTOM
The remote controller enters Custom
mode.
2 Roll the scroll wheel to select
"MODE," and then press the scroll
wheel.
3
Roll the scroll wheel to select
"ASSGN," and then press the
scroll wheel.
4
Roll the scroll wheel to select an
input source, and then press the
scroll wheel.
5 Roll the scroll wheel to select the
mode you want to assign to the
specified input source, and then
press the scroll wheel.
If the assignment is successful, after
"OK" has been displayed, the ASSGN
display (step 3) reappears.