Changing The Input Display; Minimum Speaker Impedance - Onkyo TX-SR703/703E Instruction Manual

First Time Setup—Continued

Changing the Input Display

If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or next generation HDD-compat-
ible component to the TAPE IN/OUT or VIDEO 3 IN
jacks, for to work properly, you must change this
setting.
This setting can only be changed on the AV receiver.
STANDBY/ON
STANDBY
ZONE 2
POWER
ON OFF
PURE AUDIO MULTI CH DVD VIDEO 1 VIDEO 2
1, 2
iPod photo: If you're using an iPod photo with the
DS-A1 Remote Interactive Dock, connect the DS-A1 to
the VIDEO 3 IN jacks.
1 Press the [TAPE] or [VIDEO 3]
TAPE
input selector button so that
"TAPE" or "VIDEO3" appears on
the display.
or
VIDEO 3
2
Press and hold down the [TAPE]
or [VIDEO 3] input selector but-
TAPE
ton (about 3 seconds) to change
the setting.
Repeat this step to select MD, CDR, or
HDD.
or
For the TAPE input selector, the setting
VIDEO 3
changes in this order:
TAPE
For the VIDEO 3 input selector, the set-
ting changes in this order:
VIDEO 3
Note:
HDD can be selected for the TAPE input selector or
VIDEO 3 input selector, but not both at the same time.
46
MASTER VOLUME
VIDEO 3 VIDEO 4 PHONO TAPE TUNER CD DISPLAY
PUSH TO OPEN
1, 2
→ → → →
MD CDR HDD
→ → →
HDD VIDEO 3

Minimum Speaker Impedance

If you change this setting, you must run the automatic
speaker setup again (see page 40).
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Minimum Speaker Impedance to 4
ohms.
Note:
Before you change this setting, turn down the volume.
1
Press the [RECEIVER] button,
RECEIVER
followed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "3. Speaker
Setup," and then press [ENTER].
ENTER
The Speaker Setup menu appears.
3.Speaker Setup
------------------------
0.Speaker Impedance 1.Speaker Impedance
2.Speaker Configuration
3.Speaker Distance
ENTER
4.Level Calibration
5.THX Audio Setup
6.Equalizer Settings
3
Use the Up and Down [
buttons to select "Speaker
Impedance," and then press
[ENTER].
4
Use the Left and Right [
buttons to select:
4 ohms: Select if the impedance of any
speaker is 4 ohms or more but
ENTER
less than 6.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
5 Press the [SETUP] button.
Setup closes.
Notes:
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
]/[ ]
]/[ ]
]/[ ]