Default Listening Modes - Onkyo TX-SR703/703E Instruction Manual

Adjusting the Listening Modes—Continued

Default Listening Modes

You can specify a default listening mode for each signal
format supported by each input selector. The AV receiver
will then automatically select that listening mode based
on the format of the input signal. You can select other
listening modes while listening to a source, but the
default listening mode specified here will be used next
time you turn on the AV receiver.
1 Press the [RECEIVER] REMOTE
RECEIVER
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "5. Listening
Mode Preset," and then press
ENTER
[ENTER].
The Listening Mode Preset menu
appears.
5.Listening Mode Preset
ENTER
------------------------
1.DVD
2.VIDEO1
3.VIDEO2
4.VIDEO3
5.VIDEO4
6.TAPE
7.TUNER
8.CD
9.PHONO
3
Use the Up and Down [
buttons to select an input selec-
tor, and then press [ENTER].
ENTER
The options for that input selector
appear.
5-1.ListeningMode Preset
---------VIDEO1---------
ENTER
a.Ana/PCM
:Last Valid
b.Dolby D
:Last Valid
c.DTS
:Last Valid
For the TUNER input selector, the only
signal format is "Ana/PCM."
4
ENTER
ENTER
5
Note:
]/[ ]
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Ana/PCM: Specifies the default listening mode for ana-
log sources and PCM digital audio sources.
Dolby D: Specifies the default listening mode for Dolby
Digital sources.
DTS: Specifies the default listening mode for DTS
sources.
D.F. 2ch: Specifies the default listening mode for
2-channel (2/0) stereo sources in a digital format, such as
Dolby Digital and DTS.
D.F. Mono: Specifies the default listening mode for
mono sources in a digital format, such as Dolby Digital
and DTS.
]/[ ]
176.4/192 kHz (TX-SR803/803E only): Specifies the
default listening mode for high resolution 176.4 kHz and
192 kHz digital audio sources such as DVD-Audio.
MCH PCM (TX-SR803/803E only): Specifies the
default listening mode for multichannel PCM sources
input via a HDMI IN, such as DVD-Audio.
MCH Ana: Specifies the default listening mode for the
analog multichannel DVD input. This option is only
available for the "1. DVD" input selector.
Use the Up and Down [
buttons to select a signal format,
and then use the Left and Right
[ ]/[ ] buttons to select a lis-
tening mode.
Only listening modes compatible with
each signal format can be selected.
The signal formats are explained below.
When you've finished, press the
[SETUP] button.
Setup closes.
]/[ ]
69