Erasing A Macro From The Macro 1 (Or 2) Button; Erasing All Commands And Macros That Have Been Programmed - Onkyo TX-SR601E Instruction Manual

Using the macro function
MACRO 1
ON
74

Erasing a macro from the MACRO 1 (or 2) button

1. Press and hold down any one of the seven MODE
SEND/LEARN
indicator
MACRO 2
MODE buttons
2. Press the MACRO 1 (or 2) button again.
Notes:
• If the SEND/LEARN indicator quickly flashes three times and
• If you press a button other than MACRO 1 (or 2) button in Step
ENTER
Erasing all commands and macros that have
been programmed
SEND/LEARN
This procedure will erase all the commands and macros that you
indicator
have programmed into the remote controller and return it to its
default settings. This operation will not affect the preset settings of
STANDBY
the remote controller.
1. Open the battery cover and remove the batteries from
2. While pressing and holding down the ON and
3. Press the ENTER button.
All programmed commands and macros are erased and the remote
controller returns to its factory presets.
Notes:
• Proceed to Step 3 immediately after Step 2; otherwise, the
• If you press any button other than the ENTER button in Step 3,
ENTER
buttons, press the MACRO 1 (or 2) button, and then
release both buttons.
When you press the MODE button, it lights and the SEND/
LEARN indicator lights. When you press the MACRO 1 (or 2)
button, the indicator turns off. When you release the buttons, the
indicator flashes once.
The SEND/LEARN indicator slowly flashes twice. The macro
programmed to the MACRO button is erased.
turns off, then the remote controller has exited the erasing mode
because either you have made a mistake during erasing or a
time-out has occurred because no button has been pressed.
Resume from Step 1.
2, then you will in effect be overwriting the previous macro
with a new macro.
the remote controller.
STANDBY buttons, re-insert the batteries in their
correct orientation, and then release both buttons.
The SEND/LEARN indicator flashes slowly.
The SEND/LEARN indicator lights up for about ten seconds
and then turns off.
batteries will be consumed quickly.
nothing will be erased. In this case, resume from Step 1.