Attach The Pressure Gun; Connect The High Pressure Hose; Connect To Garden Hose - Champion Power Equipment 75520 Owner's Manual & Operating Instructions

ASSEMbly
Add fuel Cont'd.
CAUTION
Use regular unleaded gasoline with a minimum
octane rating of 85 .
Do not mix oil and gasoline .
Fill tank to approximately ¼ in . (0 .64 cm) below
the top of the tank to allow for fuel expansion .
DO NOT pump gas directly into the pressure washer
at the gas station . Use an approved container to
transfer the fuel to the pressure washer .
DO NOT fill fuel tank indoors .
DO NOT fill fuel tank when the engine is running
or hot .
DO NOT overfill the fuel tank .
DO NOT light cigarettes or smoke when filling the
fuel tank .
NOTE
Our engines work well with 10% or less ethanol
blend fuels . When using blended fuels there are
some issues worth noting:
– Ethanol-gasoline blends can absorb more water
than gasoline alone .
– These blends can eventually separate, leaving
water or a watery goo in the tank, fuel valve and
carburetor .
– With gravity-fed fuel supplies, this compromised
fuel can be drawn into the carburetor and cause
damage to the engine and/or potential hazards .
– There are only a few suppliers of fuel stabilizer
that are formulated to work with ethanol blend
fuels .
– Any damages or hazards caused by using
improper fuel, improperly stored fuel, and/
or improperly formulated stabilizers, are not
covered by manufacture's warranty .
It is advisable to always shut off the fuel supply,
run the engine to fuel starvation and drain the tank
when the equipment is not in use for more than 30
days .
9
REV 75520-20121219
Attach the Pressure Gun Assembly
1 . Attach the wand (A) to the gun (B) .
2 . Rotate the 22 mm nut (clock wise) until the wand is
secure . Tighten connection . DO NOT OVER TIGHTEN .
3 . Connect the end of the high pressure hose (C) to the
gun inlet . Tighten connection clock wise . DO NOT
OVER TIGHTEN .
4 . Slide the Quick Connect sleeve towards the gun .
Insert quick connect nozzle . Be sure the quick
connect sleeve is moved forward to secure the nozzle
in place .

Connect the High Pressure Hose

Take the end of the High Pressure hose that isn't
connected to the gun inlet and insert it into the
connection on the pump . Rotate hose end (clock wise)
until secure . Tighten connection .
DO NOT OVER TIGHTEN .
Connect the Garden Hose
Take the end of the garden hose that isn't connected
to the main water supply and connect it to the pump .
Rotate the base of the hose connection until secure .
Tighten connection . DO NOT OVER TIGHTEN .
75520
ENGLISH