Panasonic VDR-D210P Service Manual page 33

14. Removal of CCD P.C.B., Filter Rubber and Optical Filter
CAUTION:
1) When removing the CCD P.C.B., take care that the
Optical Filter does not fall out.
2) Use extreme caution when removing the CCD P.C.B.
as it is easily damaged by static electricity. Use a Wrist
Strap while removing and installing.
3) Do not touch the CCD window surface.
Installation of CCD P.C.B., Filter Rubber and Optical
Filter
Install in order shown below.
1) Install the Optical Filter, taking care the direction is
correct.
Note: Make sure that no dust gets on the Optical Filter
or in the Lens Unit. Clean the Optical Filter with lens
cleaning paper dampened with lens cleaner if
necessary.
2) Install the Filter Rubber on the Optical Filter, taking care
the direction is correct.
Note: Make sure that no dust gets on the Filter
Rubber.
3) Install the CCD P.C.B. into the Lens Unit. Then, tighten
the 2 Screws (536).
Note: Do not touch the Lens Surface. Clean the surface
with lens cleaning paper dampened with lens cleaner
if necessary.
15. Installation of Zoom Motor Unit/Focus Motor Unit
Install the Zoom Motor Unit/Focus Motor Unit so that the
Shaft of the Zoom Motor Unit/Focus Motor Unit is set in the
Holder.
Boss
Zoom
Motor
Unit
Focus
Boss
Motor
Unit
Boss
Fig. D14
Shaft
Boss
Holder
Boss
Shaft
Holder
VDR-D210P / VDR-D220P / VDR-D230P / VDR-D210PC / VDR-D220PC / VDR-D230PC
16. Installation of Grip Cover Unit
1) Install the Grip Cover Unit with the 3 pins.
2) Tighten the 2 Screws (537).
33
537
Pin
537
Pins
Grip Cover Unit
(L-1)
Fig. D15