Panasonic VDR-D210P Service Manual page 31

11. Removal of LCD Case B Unit, LCD Case A Unit
Take care not to damage the F.P.C.
1) Remove the Screw (533).
2) Open the LCD and push to remove the LCD Protector.
3) Rotate the LCD (Ass'y) to access the 2 Screws (519).
4) Release the 8 Locking Tabs (L-1) and remove the LCD
Case A Unit.
5) Disconnect the F.P.C. from Connector FP8101.
6) Remove the LCD Case B Unit.
Push to remove
LCD Protector
533
519
LCD (Ass'y)
LCD Case B Unit
LCD Case A Unit
Fig. D11
519
Rotate to access
FP8101
(L-1)
(L-1)
(L-1)
VDR-D210P / VDR-D220P / VDR-D230P / VDR-D210PC / VDR-D220PC / VDR-D230PC
12. Installation of LCD Backlight P.C.B., LCD Panel Ass'y,
LCD Shield Case and LCD Case B
Use extreme care regarding LEDs when handling the LCD
Backlight P.C.B.
Install in order shown below.
1) Install the LCD Panel Ass'y onto the LCD Shield Case
with the 3 Locking Tabs (L-4) while carefully bending
the LCD F.P.C. at its base so as not to damage it.
2) Install the LCD Backlight P.C.B. onto the LCD Panel
Ass'y with the 3 Locking Tabs (L-3).
3) Install the LCD Case B with the 3 Locking Tabs (L-2).
4) Tighten the Screw (533) while keeping the LCD
Backlight P.C.B. pressed toward the left. Then, connect
the F.P.C. to Connector FP8102.
LCD Backlight P.C.B.
FP8102
(L-3)
LCD Panel Ass'y
(L-2)
(L-4)
LCD
Shield
Case
LCD Case B
31
(L-3)
533
Press
(L-3)
LEDs
(L-2)
(L-4)
(L-4)
(L-2)
Bend
LCD
F.P.C.
Fig. D12