Table of Contents
Advertisement
Setup
Note: Determine the left and right sides of the machine from the normal operating position.
Note: You will need to purchase RTV silicone sealant before installing this kit.
Contact your Authorized Toro Distributor for information on the available accessories. After you install the booms and
nozzles and before using the sprayer for the first time, adjust the boom bypass valves so that the pressure and application
rate remains the same for all booms with one or more booms turned off. Refer to Adjusting the Boom Bypass valves,
page 26.
Loose Parts
Note: Use the chart below to verify that all parts have been shipped.
Jack stands
Cover assembly
Electrical harness
Wire ties
Adapter bracket
Support bracket assembly
Socket head bolts, 3/8 x 1 inch
Prop rod
Cotter pin
Qty.
Use
4
Preparing the Workman.
4
1
1
Installing the vehicle speed sensor.
1
1
1
1
2
2
2
Installing the electrical harness.
1
1
8
1
1
4
4
Installing the control box mount.
1
4
4
1
2
2
1
Installing the prop rod assembly.
1
1
1
1
11
Advertisement
Chapters
Table of Contents
Troubleshooting
