Greasing The Spray System; Stowing The Boom Extensions - Toro 41229 Operator's Manual

Greasing the Spray System

Lubricate all bearings and bushings after every 100 hours
or once a year, whichever occurs first.
Grease Type: No. 2 General Purpose Lithium Base Grease
1. Wipe the grease fitting clean so that foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
Important
Only a few pumps of grease are required to
lubricate the system. Do not over grease. Grease will not
purge from the system.
3. Wipe off excess grease.
Figure 40
Greasing the Pivot Arms
Lubricate the boom extension bearings after every
100 hours or once a year, whichever occurs first.
Grease Type: No. 2 General Purpose Lithium Base
Grease.
1. Manually place grease on the support shaft and within
the ball seat of the hinge plate as shown in Figure 41.
2. Pump grease into the fitting located below the spring
until grease can be seen coming out of the bottom of
the pivot assembly (Fig. 41).
1
3
4
1
Figure 41
Left pivot arm shown
1. Support shaft
2. Ball seat of hinge plate
3. Repeat the procedure for opposite pivot arm.

Stowing the Boom Extensions

Use the boom restraints to lock the boom extensions in the
X position when you are not spraying.
Note: If you have the Workman spray system, the left
boom holder holds the left boom and the right boom
holder holds the right boom.
1. Pivot the left boom extension into the upright position.
Important
Do not force the boom extension past the
restraint hook when stowing or you may damage the
extension and nozzles.
2. Push up on the right restraint knob to compress the
spring and extend the hook.
3. With the spring compressed, rotate the hook to catch
the boom extension frame.
4. Release the knob allowing the hook to catch the boom
extension frame and secure it to the boom holder.
5. Repeat steps 1-4 with the right boom extension and
left boom holder.
36
2
3. Grease fitting
4. Pivot assembly