Toro 41229 Operator's Manual page 39

Problem
The Distance is inaccurate.
The monitor does not display p y
Application Rate. A li ti R t
The monitor displays 6553.5 when
in the Application Rate setting.
The monitor is erratic in operation.
The displayed measurements do
not make sense.
The monitor reads "OFL."
Possible Causes
1. The speed sensor is not
calibrated correctly.
2. The speed sensor is damaged.
1. The monitor cable is loose.
2. The flowmeter is dirty or
clogged.
3. The flowmeter is not calibrated
correctly.
4. The flowmeter is damaged.
5. The speed sensor is not
calibrated correctly.
6. The speed sensor is damaged.
7. Nozzle size and vehicle speed
configuration is unable to reach
desired application rate.
1. The monitor is not receiving
data from the speed sensor.
1. A two-way radio is too close to
the monitor or its cables.
1. The Units of Measurement is
set to a system other than what
you expect.
1. The data has exceeded the
maximum allowed.
39
Corrective Action
1. Calibrate the speed sensor.
2. Contact your Authorized
Service Dealer.
1. Connect the monitor cable.
2. Clean the flowmeter.
3. Calibrate the flowmeter
4. Contact your Authorized
Service Dealer.
5. Calibrate the speed sensor.
6. Contact your Authorized
Service Dealer.
7. Use the Nozzle Selection
Guide to choose the correct
configuration of nozzle and
vehicle speed.
1. Contact your Authorized
Service Dealer.
1. Keep two-way radios away
from the monitor and its cables.
1. Check the Units of
Measurement to ensure that it
is set correctly.
1. Press and hold the [Reset]
button to clear the monitor.