Storage - Toro 41229 Operator's Manual

Storage

1. Position the sprayer on a level surface, set the parking
brake, disengage the PTO, stop the engine, and remove
the ignition key.
2. Clean dirt and grime from the entire machine.
Important
You can wash the machine with mild
detergent and water. Do not use high pressure water to
wash the machine. Pressure washing may damage the
electrical system or wash away necessary grease at
friction points. Avoid excessive use of water, especially
near the control panel, lights, engine, and the battery.
3. Clean the spray system; refer to Cleaning the Sprayer,
page 31.
4. Add a rust inhibiting, non-alcohol based, RV
antifreeze solution to the system and run the pump for
a few minutes to circulate it through the system, then
drain the spray system as completely as possible.
5. Inspect the brakes; refer to Workman Operator's
Manual.
6. Service the air cleaner; refer to Workman Operator's
Manual.
7. Grease the sprayer; refer to Greasing the Sprayer,
page 36.
8. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
9. Check the condition of all spray hoses, replacing any
that are damaged or worn.
10. Tighten all hose fittings.
11. Paint all scratched or bare metal surfaces.
Paint is available from your Authorized Service
Dealer.
12. Store the machine in a clean, dry garage or storage
area.
13. Cover the machine to protect it and keep it clean.
Removing the Sprayer
If removing the sprayer from the Workman vehicle, use
the eyelets on the skid frame to lift the sprayer off the
vehicle using straps and an overhead hoist. The wire
harness, prop rod, and PTO shaft must be disconnected.
Lock the jackstands with the clevis pins provided. When
the sprayer is clear of the vehicle, insert the four jack
stands provided and lower the sprayer onto them. The
control box can be stored, using the existing fasteners, to
the left, rear of the tank skid.
37