Downloading The Message Data - Kyocera FS-6020 Service Manual

(4) Downloading the message data

To download the new message data, progress the following procedures.
Connecting the parallel printer cable
1. Turn OFF the power supply switch to the
printer and computer.
2. Connect the parallel printer cable between
the computer and printer.
Downloading the message data file
1. Turn ON the power to the printer.
2. Check that the message indication 1 is
indicated.
3. Input the command 2 following the DOS
prompt indication.
* Enter BOOST'SPR' in capitals.
4. Check that the message indication 3 is
indicated.
5. Input the command 4 following the DOS
prompt indication and copy the message data
file to the printer (e.g.; dm9602.spa).
6. The message indication 5 is indicated while
downloading the data file. When the message
indication 6 is indicated, which shows the
end of downloading, turn OFF the power
switch once and then turn it on again.
7. Check that the message indication 7 is
indicated after warming up the printer.
Checking the update
1. Print the status page. (See page 1-4-2.)
2. Print the status page to check that the
firmware version has been updated.
To PC
Message display
Ready
1
>echo !R! BOOT'SPR';exit;>PRN
2
Supervisor mode
3
parallel waiting
>Copy /b dm9602.spa prn
4
Downloading
5
Language Version 04
Spanish 04
6
02/06/07[1234]
Release date Check sum
Power switch: Off/On
Ready
7
Figure 1-7-10
Parallel
printer cable
Figure 1-7-9
PC DOS display
FS-6020
1-7-5