Face-Down Eject/Feedshift Section - Kyocera FS-6020 Service Manual

2-1-7 Face-down eject/feedshift section

The face-down eject/feedshift section consists of the vertical path assembly that conveys the paper which is fixed with
toner at the fixing section to the face-down tray, and the feedshift guide that operates when duplex printing is performed
(when the optional duplexer is equipped).
Normally the feedshift guide is down since it does not operate, therefore the paper that came out of the fixing section is
guided to the vertical path along the upper side of the feedshift guide and then ejected to the face-down tray by the
rotation of the face-down roller.
During the duplex printing, the feedshift guide is raised operated by the feedshift solenoid in the duplexer, and the paper
came out of the fixing section is guided to the inside of the duplexer along the lower surface of the feedshift guide.
Figure 2-1-25 Face-down eject/feedshift section
1 Rear cover
2 Feedshift guide
3 Pinch roller
4 Face-down roller
5 Face-down roller
6 Face-down paper full sensor actuator
7 Pinch roller
8 Face-down tray
FS-6020
2-1-17