Downloading Firmware Via The Parallel Interface - Kyocera FS-6020 Service Manual

FS-6020

(2) Downloading firmware via the parallel interface

To download the system firmware using the parallel interface, use the procedure below.
Connecting the parallel printer cable
1. Turn printer and PC power off.
2. Connect the parallel printer cable between
the PC and the printer.
Downloading the firmware file
1. Turn printer power on.
2. Confirm that display 1 is displayed.
3. At the DOS prompt, enter command 2.
* Enter UPGR'SYS' in capitals.
4. Confirm that message display 3 is displayed.
5. At the DOS prompt, enter command 4 so
that the system firmware (example:
s96K9100.bcmp) is copied to the printer.
6. Message display 5 is displayed during
downloading. When message display 6 is
displayed to indicate downloading is finished,
turn printer power off, then on.
7. Confirm that message display 7 is displayed
after warm-up.
1. Print a status page. (See page 1-4-2.)
2. Check that the status page shows the
Confirming upgrading
updated firmware version.
1-7-2
To PC
Message display
1
Ready
>echo !R! UPGR'SYS';exit;>PRN
2
3
Supervisor mode
parallel waiting
4
>Copy /b S96K9100.bcmp prn
5
Downloading
Version 88.00
6
8800
02/06/07[1234]
Release date Checksum
Power switch: Off/On
7
Ready
Parallel
printer cable
Figure 1-7-1
PC DOS display
Figure 1-7-2