Onkyo L-DR7 Instruction Manual page 39

Making Antenna (Aerial) Connections
Connecting an FM outdoor antenna (aerial) (non-European models only)
If the FM reception is not very clear with the supplied antenna (aerial), connect an FM outdoor
antenna (aerial) instead of the indoor FM antenna (aerial).
Connecting coaxial cable to a 75/300 ohm antenna (aerial) adapter
1 Strip the end of the coaxial cable.
15 mm
6
mm
1
/
4
in.
2 With your fingernail or a small screw-
driver, press the stoppers outward
and remove the cover.
3 Remove the transformer wire A from
slit B and insert it into slit C.
Slit C
4 Insert the end of the cable.
5 Clamp it in place with pliers.
5
6 Reinstall the cover.
Directional Iinkage
Do not use the same antenna (aerial) for both
FM and TV (or VCR) reception, since the FM and
TV (or VCR) signals can interfere with each
other. If you must use a common FM/TV (or
VCR) antenna (aerial), use a directional linkage
type splitter.
3 6
mm mm
1 1
/ /
8 4
in. in.
5
/ in.
8
Slit B
Notes
Wire A
• Install the antenna (aerial) well away from tall build-
• Keep the antenna (aerial) away from noise sources
4
• It is dangerous to put the antenna (aerial) close to
• To avoid the risk of lightning and electrical shock,
Connecting a 300 ohm ribbon
wire to a 75/300 ohm antenna
(aerial) adapter
Loosen the screws
and wrap the wire
around these
screws.
Then tighten the
screws with a
screwdriver.
ings and in an area where FM stations can be
directly received.
(neon signs, busy roads, etc.).
power lines. Keep it well away from power lines,
transformers, etc.
grounding is necessary. Follow item 14 of the
"Important Safeguards" on page 5 when you install
the outdoor antenna (aerial).
To DVD AV Controller
Directional linkage
type splitter
To TV (or VCR)
39