Onkyo L-DR7 Instruction Manual page 103

Customizing the Function Settings
Switching the S video output
You can switch the type of S-Video signals output from the S-Video connector. If you have
connected your TV using an S-Video cable, in rare cases the TV picture may appear
stretched. In such cases, switch the output from [S2] to [S1].
Language General
Video1 V2
TV Screen — 16:9(Wide)
Component Video — S1
S-Video Out — S2
Screen Saver — On
Move
Turning the Screen Saver On and Off
To prevent the TV screen or monitor from being damaged by an image that remains displayed
for a long time (a phenomenon called "screen burn"), the screen saver function is activated if
the same screen has been displayed for about five minutes.
Language General
Video1 V2
TV Screen — 16:9(Wide)
Component Video — Interlace
S-Video Out — S2
Screen Saver On
Off
Move
Items next to the Expert
window, refer to page 101 for information on how to display them.
Expert
S2:
S2 video signals are output. (Factory setting)
S1:
S1 video signals are output.
SETUP Exit
On:
The screen saver function is activated. (Factory setting)
Off:
The screen saver function is deactivated.
Exit
SETUP
mark represent advanced settings. If these items are not displayed in the
Expert
103