Premaintenance Procedures; Preparing For The Machine For Maintenance; Lubrication; Lubricating The Grease Fittings - Toro 34215 Operator's Manual

Premaintenance
Procedures
CAUTION
Raising the machine for service or maintenance
relying solely on mechanical or hydraulic jacks
could be dangerous. The mechanical or hydraulic
jacks may not be enough support or may
malfunction allowing the machine to fall, which
could cause injury.
Do not rely solely on mechanical or hydraulic jacks
for support. Use adequate jack stands or equivalent
support.
Preparing for the Machine for
Maintenance
Perform the following before servicing, cleaning, or making
any adjustments to the machine.
1. Move the machine to a level surface.
2. Shut off the engine, set the parking brake, wait for all
moving parts to stop.
3. Remove the key from the key switch.

Lubrication

Lubricating the Grease Fittings

Service Interval: Every 100 hours
Grease type: National Lubricating Grease Institute (NGLI)
grade #2 multi-purpose gun grease.
Note: Refer to the lubrication chart for the grease points
and service intervals.
Lubrication Chart
Fitting Locations
1. Wheel bearings
2. Kingpin pivots
2. Front axle pivots
3. Steering control
pivot
1. Stop engine, set the parking brake, wait for all moving
parts to stop, and remove key.
2. Wipe clean the grease fittings with a rag
3. Connect a grease gun to the fitting
4. Pump grease into the fittings until grease begins to
ooze out of the bearings.
5. Wipe up any excess grease.
51
Initial Pumps Number of
Places
1 to 2
1 to 2
1 to 2
1 to 2
Figure 57
(Figure
(Figure 57).
2
2
1
1
57).