Toro 34215 Operator's Manual page 44

4. Rotate the strainer bowl counterclockwise and remove
the bowl and screen from the body of the strainer
(Figure 48).
Note: Remove the strainer bowl by hand.
Note: Replace the gasket or screen or both if these
parts are worn or damaged
Figure 48
1. Strainer body
2. Gasket
5. Allow any residual chemical solution to drain from the
strainer body.
Note: Dispose of the waste solution according to local
codes and the chemical manufacturer's instructions.
6. Use a soft-bristle brush and clean water to clean the
screen and bowl
7. Install the screen into the strainer body
8. Install the strainer bowl onto the strainer body and
hand tighten the bowl
9. Rotate the handle for the sprayer pump supply valve
90° clockwise (Figure
3. Screen
4. strainer bowl
(.Figure
(Figure 48).
47).
Cleaning the Sprayer Nozzle
Service Interval: After each use
1. Rotate the nozzle cap 90° counterclockwise and
remove the cap from the nozzle body
1. Nozzle body
2. Strainer
3. Gasket
4. Sprayer tip
2. Remove the sprayer tip, gasket, and strainer from the
nozzle body
Note: Replace any worn or damaged nozzle parts.
3. Use a soft-bristle brush and clean water to clean the
nozzle tip, gasket, and strainer.
4. Assemble the strainer into the nozzle body
5. Assemble the sprayer tip and gasket into the nozzle
cap (Figure
6. Install the tip, gasket, and cap onto the nozzle body
(.Figure
48).
Note: Use the slot to rotate the atomizer
the sprayer tip forward (in-line with the flow-regulator
case of the nozzle body).
7. Rotate the nozzle cap 90° clockwise
8. Repeat steps
nozzles.
44
Figure 49
5. Nozzle cap
6. Atomizer
7. Slot
8. Regulator case
(Figure 49).
49).
49).
1 through 7 for the 2 other sprayer
(Figure 49).
(Figure 49).
(Figure 49) of
(Figure 49).