Table of Contents
Advertisement
Spraying with the Spray Wand
WARNING
The spray wand traps liquids under high pressure,
even when engine is off. High pressure spray
discharge could cause serious injury or death.
• Keep clear of nozzle and do not direct the spray
or stream from the wand at people, pets, or
non-work area property.
• Do not direct spray at or near electrical power
components or source.
• Do not repair the spray wand, hoses, seals,
nozzle, or other wand components; always
replace them.
• Do not attach hoses or other components to the
nozzle at the end of the spray wand.
• Do not attempt to disconnect the spray wand
from the unit while the sprayer system is
pressurized.
• Do not use spray wand if trigger lock is damaged
or missing.
• Rotate the spray wand lock to the Off position
when job is complete.
1. Remove the wand from the holder at the right side of
the machine
(Figure
Figure 53
1. Holder
2. Trigger
3. Trigger lock
2. Firmly grip the spray wand and point it in the direction
that you will spray.
Note: Wand may recoil; make sure to hold the wand
securely.
3. Adjust the pump pressure to the spray wand perform
the following:
•
To increase pump pressure to the wand, rotate the
wand pressure control counterclockwise
54).
53).
4. Wand
5. Nozzle
(Figure
1. Sprayer wand pressure control
•
To decrease pressure to the wand, rotate the
control clockwise direction
•
To shut off pressure to the wand, rotate the wand
pressure control clockwise until the valve for the
control is closed
4. Squeeze the trigger to the spray wand handle to begin
spraying; lock the trigger in place if desired
5. When finished spraying, perform the following:
A. Rotate the spray wand lock to the Off position(if
applicable) and release the trigger
B. Rotate the sprayer wand pressure control
clockwise to the Off position
C. Put the wand back into the wand holder
53).
Transporting the Machine
Machine weight: 227 kg (500 lb)—both sprayer tank and
hopper empty; 389 kg (857 lb)—both sprayer tank and
hopper full
CAUTION
This machine does not have proper turn signals,
lights, reflective markings, or a slow moving vehicle
emblem. Driving on a street or roadway without
such equipment is dangerous and can lead to
accidents causing personal injury. Driving on a
street or roadway without such equipment may also
be a violation of State laws and the operator may be
subject to traffic tickets and/or fines.
Do not drive a machine on a public street or
roadway.
47
Figure 54
(Figure
54).
(Figure
54).
(Figure
(Figure
(Figure
54).
53).
53).
(Figure
Advertisement
Table of Contents
