Default Ssid And Radio Behavior; Enable Radio Interfaces; Ssid - Cisco Aironet 1130AG Hardware Installation Manual

Chapter 6 Troubleshooting

Default SSID and Radio Behavior

In Cisco IOS Relese 12.3(2)JA2 and earlier, the access point radios are enabled by default and the default
SSIDs are tsunami.
In Cisco IOS Release 12.3(4)JA, the access point radios are disabled by default, and there are no default
SSIDs. You must create an SSID and enable the radio before the access point will allow wireless
associations from other devices. These changes to the default configuration improve the security of
newly installed access points. Refer to the
for instructions on configuring the SSID and the
instructions on enabling the radio interfaces.

Enable Radio Interfaces

To enable the radio interfaces, follow these instructions:
Use your web-browser to access your access point.
Step 1
When the Summary Status page displays, click Network Interfaces > Radio0-802.11B or
Step 2
Radio0-802.11G and the radio status page displays.
Click Settings and the radio settings page displays.
Step 3
Click Enable in the Enable Radio field.
Step 4
Click Apply.
Step 5
Click Network Interfaces > Radio0-802.11A and the radio status page displays.
Step 6
Step 7 Click Settings and the radio settings page displays.
Step 8 Click Enable in the Enable Radio field.
Click Apply.
Step 9
Close your web-browser.
Step 10

SSID

Wireless clients attempting to associate with the access point must use the same SSID as the access point.
If a client device's SSID does not match the SSID of an access point in radio range, the client device will
not associate. The access point default SSID is tsunami. Refer to the
section on page 3-13
The default SSID (tsunami) is not supported in access points running Cisco IOS Release 12.3(4)JA. You
Note
must configure an SSID before client devices can associate to the access point.
OL-6226-02
"Configuring Basic Security Settings" section on page 3-10
for instructions on how to configure an SSID.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
"Enable Radio Interfaces" section on page 6-5
"Using the Express Security Page"
Checking Basic Settings
for
6-5