Configuring Power Using The Cli - Cisco Aironet 1130AG Hardware Installation Manual

Chapter 6 Troubleshooting
•

Configuring Power Using the CLI

Intelligent Power Management support is dependent on the version of software resident in the Cisco
switch that is providing power to the access point. Each Cisco switch should be upgraded to support
Intelligent Power Management. Until the software is upgraded, you can configure the access point to
operate with older switch software using the following Cisco IOS CLI command:
[no] power inline negotiation {prestandard source | injector H.H.H}
(where H.H.H is the MAC address of the switch port to which the access point is connected)
You can use this Cisco IOS CLI command to inform the access point of the following:
•
•
Refer to
corresponding Cisco switch power command.
If the access point receives power through PoE, the output current of the power sourcing equipment
Caution
(PSE) cannot exceed 400 mA per port. The power source must comply with IEEE802.3af or IEC60950
for limited power sources.
After completing your configuration changes, you must remove the serial console cable from the access
Note
point.
OL-6226-02
%CDP_PD-2-POWER_LOW: All radios disabled- HIGH_POWER_CLASSIC_NOT_
CONFIGURED inline power source platform=<platform name> MAC address=
<xxxx.xxxx.xxxx>—This message indicates the access point is in low power mode with all radios
disabled and has detected a Cisco switch that does not support Intelligent Power Management, but
should be able to supply sufficient power. The access point must be configured for pre-standard
compatibility.
The< platform name> indicates the Cisco platform detected by the access point. The
<xxxx.xxxx.xxxx> indicates the MAC address of the switch port.
Note You need to upgrade the software on the Cisco switch to support Intelligent Power
Management or configure the access point for pre-standard compatibility.
The Cisco switch does not support Intelligent Power Management but should be able to supply
sufficient power.
A power injector is being used to supply sufficient power and the Cisco switch does not support
Intelligent Power Management.
Table 6-2 for information on when to use this special Cisco IOS command and the
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Low Power Condition
6-9