Checking the Access Point LEDs
Checking the Access Point LEDs
If your access point is not working properly, check the Status LED on the top panel or the Ethernet and
Radio LEDs in the cable bay area. You can use the LED indications to quickly assess the unit's status.
Figure 6-1
access point browser interface).
Figure 6-1
1
2
Note
To view the Ethernet and Radio LEDs you must open the access point cover (refer to the
Access Point Cover" section on page
Note
When the access point cover is opened, the Status LED colors are not visible.
There can be slight color variations in the Status LED of each access point.
Note
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
6-2
shows the access point LEDs (for additional information refer to the Event Log using the
Access Point LEDs
2
3
4
Status LED
Access point cover
1
3
Ethernet LED
4
Radio LED
2-9).
Chapter 6
Troubleshooting
"Opening the
OL-6226-02