Remove The Cushion For Rear Access - Toro GrandStand 74558 Operator's Manual

Figure 32
1. Remove battery
Remove the Cushion for Rear
Access
The cushion can be removed for rear access to the
machine for maintenance or adjustment.
1. Lower the platform.
2. Remove the hairpin cotter pins on each side of the
cushion.
3. Slide the cushion to the side to remove it from the
pins and plastic bushings on both sides.
4. Lower the cushion to the platform.
5. Perform any maintenance or adjustment on the
machine.
6. Install the plastic bushings onto the pins (Figure 33).
7. Raise the cushion and slide it onto the pins on both
sides of the machine.
8. Slide the plastic bushings into the cushion bracket
and secure them with a hairpin cotter pin (Figure 33).
2. With two people, lift the
front end of the mower
(ensure the platform is up)
1. Pin
2. Cushion bracket
28
Figure 33
3. Hairpin cotter pin
4. Plastic bushing