Transporting Machines; Loading Machines - Toro GrandStand 74558 Operator's Manual

3. Release the parking brake.
4. Push the machine to the desired location.
5. Set the parking brake.
6. Close the by-pass valves, but do not overtighten
them.
Important: Do not start or operate the
machine with the by-pass valves open. Damage
to system may occur.

Transporting Machines

Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
necessary brakes, lighting, and marking as required by
law. Please carefully read all the safety instructions.
Knowing this information could help you, your family,
pets or bystanders avoid injury.
To transport the machine:
1. Raise the platform of the machine before driving up
onto the trailer or truck.
2. If using a trailer, connect it to the towing vehicle
and connect the safety chains.
3. If applicable, connect the trailer brakes.
4. Load the machine onto the trailer or truck.
5. Stop the engine, remove the key, set the brake, and
close the fuel valve.
6. Use the metal tie down loops on the machine to
securely fasten the machine to the trailer or truck
with straps, chains, cable, or ropes (Figure 23).
Figure 23
1. Traction unit tie down loop

Loading Machines

Use extreme caution when loading units on trailers or
trucks. One full width ramp that is wide enough to
extend beyond the rear tires is recommended instead of
individual ramps for each side of the unit (Figure 24).
The lower rear section of the tractor frame extends
back between the rear wheels and serves as a stop for
tipping backward. Having a full width ramp provides
a surface for the frame members to contact if the
unit starts to tip backward. If it is not possible to use
one full width ramp, use enough individual ramps to
simulate a full width continuous ramp.
The ramp should be long enough so that the angles
do not exceed 20 degrees (Figure 24). A steeper angle
may cause mower components to get caught as the unit
moves from ramp to trailer or truck. Steeper angles
may also cause the unit to tip backward. If loading on
or near a slope, position the trailer or truck so it is on
the down side of the slope and the ramp extends up the
slope. This will minimize the ramp angle. The trailer or
truck should be as level as possible.
Important: Do Not attempt to turn the unit while
on the ramp; you may lose control and drive off
the side.
Avoid sudden acceleration when driving up a ramp and
sudden deceleration when backing down a ramp. Both
maneuvers can cause the unit to tip backward.
Loading a unit onto a trailer or truck increases
the possibility of backward tip-over and could
cause serious injury or death.
• Use extreme caution when operating a unit
on a ramp.
• Use only a single, full width ramp; Do Not
use individual ramps for each side of the
unit.
• If individual ramps must be used, use
enough ramps to create an unbroken ramp
surface wider than the unit.
• Do not exceed a 20 degree angle between
ramp and ground or between ramp and
trailer or truck.
• Avoid sudden acceleration while driving unit
up a ramp to avoid tipping backward.
• Avoid sudden deceleration while backing
unit down a ramp to avoid tipping backward.
22