Motion Control Levers - Toro GrandStand 74558 Operator's Manual

1. Switch
2. 1/8 inch (3mm)
12. Tighten the switch screws.
Adjusting the Neutral Postion for the

Motion Control Levers

Important: Ensure the tracking of the mower is
correct after adjusting the motion control levers.
Adjusting the tracking and aligning the motion
control levers front to back is the same procedure
(Figure 66).
Note: Adjust the horizontal alignment before the front
to back alignment.
If the motion control levers do not align front to back,
or the right side control lever does not move easily into
the neutral lock position, adjustment is required.
1. After the horizontal alignment is finished, check the
front to back alignment (Figure 66).
Figure 65
3. Right motion control lever
in the neutral unlocked
position
1. Left motion control lever
2. Right motion control lever
2. Rotate the thumb adjustments on either side. Adjust
them in quarter-turn increments until the right side
control lever moves easily into the neutral lock
position and the control levers align.
3. Check for proper tracking. Refer to Adjusting the
Tracking in the Maintenance Section.
1. Left thumb adjustment
2. Right thumb adjustment
46
Figure 66
3. Neutral locked position
4. Align the control levers
front to back
Figure 67
3. Platform down