Belt Maintenance; Replacing The Mower Deck Belt - Toro GrandStand 74558 Operator's Manual

Figure 59
1. Jam Nut
2. Yoke
3. Clevis pin
11. After the brake is adjusted, the lever switch needs
to be checked.
12. Check the gap between the brake lever and the
switch as shown in Figure 60. The gap needs to be
an 1/8 inch (3mm) with the brake engaged.
13. If needed, loosen the screws holding the switch and
adjust the switch.
Figure 60
1. 1/8 inch (3mm) gap
needed between switch
and brake lever
2. Brake lever
4. Hairpin cotter pin
5. Lower brake lever
3. Switch

Belt Maintenance

Replacing the Mower Deck
Belt
Service Interval: Every 100 hours—Check the mower
deck belt.
Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks and cracks
are signs of a worn deck belt. Replace the deck belt if
any of these conditions are evident.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Unlatch and remove the belt covers.
4. Loosen the front idler pulley by loosening the nut.
5. Remove the worn mower belt (Figure 61).
6. Install the new mower belt around the deck pulleys
and clutch pulley (Figure 61 ).
7. Using a ratchet in the idler arm, tighten the idler
pulley until the spring is stretched 5-3/4 inches (14.6
cm) from hook to hook (Figure 61 ).
8. Tighten the front idler pulley by tightening the nut.
9. Install the belt covers onto the cutting unit and
secure the latches.
43