Lubrication; How To Grease; Lubricating The Machine - Toro GrandStand 74558 Operator's Manual

Lubrication

Grease with No. 2 general purpose lithium base or
molybdenum base grease.
Lubricate the traction rollers with a dry lubricant
(PTFE).

How to Grease

1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
4. Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of
the bearings.
5. Wipe up any excess grease.

Lubricating the Machine

Service Interval: Every 200 hours—Grease the mower
deck spindles (more often in dirty or
dusty conditions).
Every 200 hours—Grease the lift
linkage (more often in dirty or dusty
conditions).
Every 800 hours/Yearly (whichever
comes first)—Grease the front wheel
bearings (more often in dirty or dusty
conditions).
Every 800 hours/Yearly (whichever
comes first)—Grease the front caster
pivots (more often in dirty or dusty
conditions).
Every 800 hours/Yearly (whichever
comes first)—Lubricate the traction
rollers (more often in dirty or dusty
conditions).
Use the following graphics for locating the grease points.
Lubricate the traction rollers with a dry lubricant.
29
Figure 34
Figure 35
Figure 36