Figure 33
1. Pin
2. Hairpin cotter
Releasing the Cushion for
Rear Access
Service Interval: Every 500 hours
You can release the cushion for rear access to the
machine for maintenance or adjustment.
1.
Lower the platform.
2.
Loosen the twist knobs on each side of the
machine
(Figure
Figure 34
1. Twist knob
3.
Remove the cushion and lower it to the platform.
4.
Perform any maintenance or adjustment on the
machine.
5.
Raise the cushion, and slide it onto the pins on
both sides of the machine.
6.
Tighten the twist knobs.
3. Cylinder lock
34).
2. Cushion
Lubrication
Greasing the Machine
Grease with No. 2 lithium or molybdenum grease.
1.
Disengage the PTO and set the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Clean the grease fittings with a rag.
Note:
Make sure to scrape any paint off the
front of the fitting(s).
g215387
4.
Connect a grease gun to the fitting.
5.
Pump grease into the fittings until grease begins
to ooze out of the bearings.
6.
Wipe up any excess grease.
Greasing the Accessory
Frame
Grease the pivots of the accessory frame at the
locations shown in
g032556
1. Grease these pivots.
28
Figure
35.
Figure 35
g032690