Installing The Hairpin Cotter Pins And Washers; Checking The Tire Pressure; Installing The Mid Size Weight - Toro 30436 Operator's Manual

5
St e p
Parts needed for this step:
2 Hairpin cotter pins
Installing the Hairpin Cotter
Pins and Washers
Unused height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
1. On the opposite side of the muffler, install unused
washers and hairpin cotter pins into front and rear
height–of–cut pins (Fig. 7).
3
2
1
Figure 7
1. Hairpin cotter
2. Unused spacers
6
St e p
No parts needed for this step.

Checking the Tire Pressure

Refer to Page 36 for the correct correct tire pressure.
m-6505
3. Height–of–cut post
18
7
St e p
Parts needed for this step:
1 Rear weight
2 Capscrews
2 Washers
2 Nuts

Installing the Mid Size Weight

1. Remove lag screws securing weight to the shipping
crate. Remove the weight and discard the screws.
2. Secure the weight to rear of the frame with
2 capscrews, washers and nuts (Fig. 8).
Note: The weight mounted in the rear position is
recommended, except when a Tru–Trak
installed.
1
3
2
Figure 8
1. Weight
2. Capscrew
Warning
With the weight installed in the rear position, the
front end of the machine can rapidly raise up
when the mower is removed. This could cause
serious injury to you or bystanders.
Support the rear of the machine when
removing the mower from the carrier frame.
R
Sulky is
4
3. Washer
4. Nut