Toro Mower Safety - Toro 30436 Operator's Manual

Disconnect battery or remove spark plug wire before
making any repairs. Disconnect the negative terminal
first and the positive last. Reconnect positive first and
negative last.
Use care when checking blades. Wrap the blade(s) or
wear gloves, and use caution when servicing them.
Only replace blades. Never straighten or weld them.
Keep hands and feet away from moving parts. If
possible, do not make adjustments with the engine
running.
Charge batteries in an open well ventilated area, away
from spark and flames. Unplug charger before
connecting or disconnecting from battery. Wear
protective clothing and use insulated tools.
Keep all parts in good working condition and all
hardware tightened. Replace all worn or damaged
decals.

Toro Mower Safety

The following list contains safety information specific to
Toro products and other safety information you must
know.
This product is capable of amputating hands and feet and
throwing objects. Always follow all safety instructions to
avoid serious injury or death.
This product is designed for cutting and recycling grass or,
when equipped with a grass bagger, for catching cut grass.
Any use for purposes other than these could prove
dangerous to user and bystanders.
General Operation
Allow only responsible adults who are familiar with
the instructions to operate the machine.
Be sure the area is clear of other people before
mowing. Stop the machine if anyone enters the area.
Do not mow in reverse unless absolutely necessary.
Always look down and behind before and while
backing.
Be aware of the mower discharge direction and do not
point it at anyone. Do not operate the mower without
either the entire grass catcher or the guard in place.
Slow down before turning. Sharp turns on any terrain
may cause loss of control.
Turn off blades when not mowing.
Keep hands, feet, hair and loose clothing away from
attachment discharge area, underside of mower and
any moving parts while engine is running.
Stop the engine before removing the grass catcher or
unclogging the chute.
Mow only in daylight or good artificial light.
Watch for traffic when operating near or crossing
roadways.
Do not touch equipment or attachment parts which
may be hot from operation. Allow to cool before
attempting to maintain, adjust or service.
Use only Toro-approved attachments. Warranty may
be voided if used with unapproved attachments.
Slope Operation
Slopes and ramps are a major factor related to
loss-of-control and accidents, which can result in severe
injury or death. All slopes and ramps require extra
caution. If you feel uneasy on a slope, do not mow it.
DO
Remove obstacles such as rocks, tree limbs, etc. from
the mowing area.
Watch for holes, ruts or bumps. Tall grass can hide
obstacles.
Use slow speed so that you will not have to stop while
on the slope.
Use extra care with grass catchers or other
attachments. These can change the stability of the
machine.
Keep all movement on slopes slow and gradual. Do
not make sudden changes in speed or direction.
Avoid starting or stopping on a slope. If tires lose
traction, disengage the blades.
Check carefully for overhead clearances (i.e. branches,
doorways, electrical wires) before driving under any
objects and do not contact them.
Mow slopes side to side.
DO NOT
Do not mow slopes greater than 15 degrees.
Avoid turning on slopes. If you must turn, turn slowly
and gradually downhill, if possible.
Do not mow near drop-offs, ditches, or embankments.
The machine could suddenly turn over if a wheel goes
over the edge of a cliff or ditch, or if an edge caves in.
Do not mow on wet grass. Reduced traction could
cause sliding.
Do not use a grass catcher on steep slopes. Heavy
grass bags could cause loss of control of the machine.
5