Installing The Speed Control Rod; Installing The Hairpin Cotter Pins And Washers; Checking The Tire Pressure - Toro 30433 Operator's Manual

Parts needed for this step:
1 Cotter pin
1 Washer
Installing the Speed Control
Rod
1. Install the swivel into the speed control crank and
secure it with a washer and cotter pin (Fig. 6).
Note: If necessary move the speed control lever until the
swivel will go into the speed control crank.
4
5
6
Figure 6
1. Speed control rod
2. Swivel
3. Nut
1
3
2
3
m–6602
4. Speed control crank
5. Cotter pin
6. Washer
17
Parts needed for this step:
2 Hairpin cotter pins
Installing the Hairpin Cotter
Pins and Washers
Unused height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
1. On the opposite side of the muffler, install unused
washers and hairpin cotter pins into front and rear
height–of–cut pins (Fig. 7).
3
2
1
Figure 7
1. Hairpin cotter
2. Unused spacers
No parts needed for this step.

Checking the Tire Pressure

Refer to Page 32 for the correct correct tire pressure.
m-6505
3. Height–of–cut post