Installing The Hairpin Cotter Pins And Washers; Checking The Tire Pressure - Toro 30430 Operator's Manual

Parts needed for this step:
2 Hairpin cotter pins
Installing the Hairpin Cotter
Pins and Washers
Unused height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
1. On the opposite side of the muffler, install unused
washers and hairpin cotter pins into front and rear
height–of–cut pins (Fig. 10).
3
2
1
Figure 10
1. Hairpin cotter
2. Unused spacers
m-6505
3. Height–of–cut post
17
No parts needed for this step.

Checking the Tire Pressure

Refer to Page 29 for the correct correct tire pressure.