Installing The Hairpin Cotter Pins And Washers; Installing The Rear Weight - Toro 30319 Operator's Manual

Note: Make sure brake rod is installed in front (F)
mounting hole in idler bracket.
2
3
Figure 10
1. Upper control bar
2. Parking brake lever
Parts needed for this step:
2 Hairpin cotter pins
Installing the Hairpin Cotter
Pins and Washers
Unused height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
1. On the opposite side of the muffler, install unused
washers and hairpin cotter pins into front and rear
height–of–cut pins (Fig. 11).
1
m–5233
3. Fixed bar
17
3
2
1
Figure 11
1. Hairpin cotter
2. Unused spacers
Parts needed for this step:
1 Rear weight
2 Capscrews 5/16 x 1–1/2 inch
2 Washers 5/16 inch
2 Nuts 5/16 inch

Installing the Rear Weight

1. Remove lag screws securing weight to shipping crate.
Remove weight and discard screws.
2. Secure weight to rear of frame with 2 capscrews,
washers and nuts (Fig. 26).
Note: The weight mounted in the rear position is
recommended, except when a Tru–Trak Sulky is
installed.
m-6505
3. Height–of–cut post