Table of Contents
Advertisement
2
Figure 29
1. Paper element
Installing the Foam and Paper Elements
Important
To prevent engine damage, always operate
the engine with the complete foam and paper air cleaner
assembly installed.
1. Carefully place the foam element onto the paper air
cleaner element (Fig. 27).
2. Place the air cleaner assembly onto the air cleaner base
(Fig. 27). Secure with nut.
3. Install the air cleaner cover and secure latches
(Fig. 27).
Servicing the Engine Oil
Service Interval and Specification
Change oil:
After the first 8 operating hours.
After every 100 operating hours.
Note: Change oil more frequently when operating
conditions are extremely dusty or sandy.
Oil Type: Detergent oil (API service SE, SF or SG)
Crankcase Capacity: with new filter, 57–1/2 oz. (1.7 l)
without new filter, 51 oz. (1.5 l)
1
m–4695
2. Rubber seal
31
Viscosity: See table below
Checking the Engine Oil Level
1. Park the machine on a level surface.
2. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the
key.
3. Clean around the oil dipstick (Fig. 30) so dirt cannot
fall into the filler hole and damage the engine.
4. Unscrew the oil dipstick and wipe the metal end clean
(Fig. 30).
5. Thread the oil dipstick fully onto the filler tube
(Fig. 30). Pull the dipstick out and look at the metal
end. If oil level is low, slowly pour only enough oil
into the filler tube to raise the level to the full mark.
Important
Do not overfill the crankcase with oil
because the engine may be damaged.
1
3
Figure 30
1. Oil dipstick
2. Metal end
2
3. Filler tube
Advertisement
Table of Contents
