Installing The Hairpin Cotter Pins And Spacers; Installing The Handle Assembly - Toro 30317 Operator's Manual

Step
2
Installing the Hairpin Cotter
Pins and Spacers
Parts needed for this step:
Qty.
2
Hairpin cotter pin
6
Spacers
Procedure
Unused height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
Note: Make sure there is at least one spacer used on each
height–of–cut post.
1. Remove the existing rear hairpin cotter pins from the
rear height–of–cut posts (Fig. 5).
2. Install a spacer onto both rear height–of–cut posts and
install the hairpin cotter pins (Fig. 5).
2
3
Figure 5
1. Hairpin cotter
2. Spacer
3. Install a spacer onto both front height–of–cut posts and
install the hairpin cotter pins.
Part
1
m–7584
3. Height–of–cut post (rear
shown)
4. On the opposite side of the muffler, install unused
spacers onto front and rear height–of–cut pins and insert
the hairpin cotter pins (Fig. 6).
3
2
1
1. Hairpin cotter
2. Unused spacers
Step
3

Installing the Handle Assembly

Parts needed for this step:
Qty.
1
Handle assembly
4
Flanged bolt, 3/8 x 1 inch
4
Flange nut, 3/8 inch
Procedure
1. Align handle with upper mounting holes in rear frame
(Fig. 7).
2. Secure the handle at each upper mounting hole with a
flange bolt (3/8 x 1 inch) and flange nut (Fig. 7).
3. Select the low position for the lower mounting hole
(Fig. 7).
4. Secure the handle at each lower mounting hole with a
flange bolt (3/8 x 1 inch) and flange nut (Fig. 7).
15
Figure 6
3. Height–of–cut post (front
shown)
Part
m-6505