Using The Mid-Size Weight - Toro 30436 Operator's Manual

7. Adjust the control rod length by rotating the control
rod in the rod fitting (Fig. 5).
8. Install hairpin cotter between drive levers and neutral
locks and into clevis pins (Fig. 23).
Note: Make sure the clevis pins are inserted into the
neutral locks.
9. Perform the hydraulic linkage adjustments when the
handle height is changed. Refer Hydraulic Linkage
Adjustments on page 40.
Using the Mid–Size Weight
This machine includes a weight installed in the rear
position (Fig. 26).
The weight mounted in the rear position is
recommended, except when a Tru–Trak
installed.
The weight mounted in the back position, must be
removed when the when a Tru–Trak
installed.
Warning
With the weight installed in the rear position, the
front end of the machine can rapidly raise up
when the mower is removed. This could cause
serious injury to you or bystanders.
Support the rear of the machine when
removing the mower from the carrier frame.
1
3
2
Figure 26
1. Weight mounted in rear
position
2. Capscrew
R
Sulky is
R
Sulky is
4
3. Washer
4. Nut
28