Installing The Hairpin Cotter Pins And Washers - Toro 30261TE Operator's Manual

5
2
3
Figure 9
1. Control rod
2. Fixed control bar
3. Parking brake lever
4. Upper control bar
5. Check the parking brake adjustment (Fig. 10). Refer to
Checking the Brakes, page 30.
Note: Make sure brake rod is installed in front (F)
mounting hole in idler bracket.
2
3
Figure 10
1. Upper control bar
2. Parking brake lever
4
1
m–6443
5. 1 to 1–1/4 inch
(25–32mm) gap
6. Fitting
1
m–5233
3. Fixed bar
17
Parts needed for this step:
2 Hairpin cotter pins
Installing the Hairpin Cotter
Pins and Washers
Spare height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
1. On the opposite side of the muffler, install extra
washers and hairpin cotter pins into front and rear
height–of–cut pins (Fig. 11).
3
2
1
Figure 11
1. Hairpin cotter
2. Extra spacers
m-6505
3. Height–of–cut post