Adjusting The Handle Height - Toro 30436 Operator's Manual

3
4
1
Figure 22
1. Center Gage Wheels and
Spacer
2. Nut

Adjusting the Handle Height

The handle position can be adjusted to match the
operator 's height preference.
1. Remove the hairpin cotter pin and clevis pin from the
drive lever and neutral lock (Fig. 23).
4
3
5
7
m–6639
Figure 23
1. Left handle shown
2. Neutral lock
3. Clevis pin
4. Drive lever
2. Loosen the nuts holding the swivel connected to the
speed control crank (Fig. 24).
4
2
m–6510
3. Bolt
4. Washer
6
1
2
5. Control rod
6. Operator Presence
Control lever (OPC)
7. Hairpin cotter
27
4
5
6
Figure 24
1. Speed control rod
2. Swivel
3. Nut
3. Loosen the upper flange bolts (3/8 x 1 inch) and flange
nut securing handle to rear frame (Fig. 25).
4. Remove the lower flange bolts (3/8 x 1 inch) and
flange nuts securing handle to rear frame (Fig. 25).
5. Pivot handle to desired operating position and install
lower flange bolts (3/8 x 1 inch) and flange nuts into
mounting holes. Tighten all flange bolts.
7
8
9
4
2
6
Figure 25
1. Handle assembly
2. Rear frame
3. Flange nut, 3/8 inch
4. Flange bolt, 3/8 x 1 inch
5. Upper mounting hole
6. Adjust the swivel on the speed control rod and tighten
the nuts against the swivel (Fig. 24).
1
3
2
3
m–6602
4. Speed control crank
5. Cotter pin
6. Washer
5
1
3
m–6600
6. Lower mounting holes
7. Low position
8. High position
9. Flange bolt, 3/8 x
1–1/4 inch