Table of Contents
Advertisement
STEP 15 HANG DECORATIVE PANELS- FLUSH INSTALLATION ONLY (Cont.)
5. Lift the decorative panel to hang the panel on the
Freezer Drawer. Make sure it is oriented correctly (top is
up).
6. Align the brackets on the panel with the brackets on the
door and push into place.
7. Using supplied washer-head screws, secure panel
brackets mounted on back of the wooden panels to the
drawer. These are located on the left and right sides of
the drawer.
8. Thread set screws into each of the panel brackets
attached to the doors Each bracket will have 2 set
screws threaded into it (see illustration).
STEP 16 LAYOUT DECORATIVE GRILLE
PANEL- FLUSH INSTALLATION
ONLY
Grille area will also have decorative wood panel
attached to installed steel bracket. Pilot holes are
necessary to prevent splitting and cracking of wood
panel.
1. Cut wooden grille panel to specified dimensions as
noted on page 11.
2. Lay the grille panel face down on a non-scratch
surface.
3. Mark a vertical centerline on the back side of the grille
panel.
4. Lay supplied TEMPLATE to the back of the grille
panel with the lettering face up. Align the top, side,
and centerline of the template with the top side and
centerline of the door. Tape the template in place
using masking tape.
5. Using a 1/8" wood drill bit, drill pilot holes into the grille
panel 1/4" deep.
6. Remove tape and discard template.
Installation Instructions
23
Panel
Bracket
Set Screws
STEP 17 INSTALL GRILLE PANEL- FLUSH
INSTALLATION ONLY
1. Pull grille panel bracket in an outward motion allowing
it to swing out and up to the fully open position.
2. Lay the grille panel on top of the grille panel bracket
and align the pilot holes with the bracket holes from the
underside.
3. Fasten the grille panel to the grille panel bracket using
provided screws in bracket hardware kit.
Door
Bracket
Advertisement
Table of Contents
