Step 13. Attach Brackets To Panels; Step 12. Layout Decorative Door Panels - Monogram ZICS360NHLH Installation Instructions Manual

STEP 12 LAYOUT DECORATIVE DOOR PANELS - FLUSH INSTALLATION ONLY (Cont.)
10. Using a pencil, trace the outline of the notch out of the
template at the bottom corner of each door. This mark
will provide a guide for routing wood to provide relief for
door hinge at bottom of door panel.
11. Route out the traced areas on the rear of each panel
1/4" deep and discard the door panel templates.
STEP 13 ATTACH BRACKETS TO FRESH FOOD PANEL- FLUSH INSTALLATION ONLY
Locate wood panel brackets and wood panel screws in
Flush Inset Hardware Kit located inside a drawer in the
refrigerator. These brackets will install to the back of
the decorative wood panels to provide attachment to
refrigerator door brackets already installed on the door
and drawer.
For LH Door (hinges on the left side when facing
refrigerator)
1. Align the four tapered holes in the top left hand panel
bracket with the four pilot holes at the top hinge side of
the Fresh Food panel making sure the angled portion of
the bracket is facing the perimeter of the door. Fasten
the bracket using four screws.
2. Align the four tapered holes in the bottom left hand
panel bracket with the four pilot holes at the bottom
hinge side of the Fresh Food panel making sure the
angled portion of the bracket is facing the perimeter of
the door. Fasten the bracket using four screws.
Top Right
Panel
Bracket
Installation Instructions
Top Back
of Panel
The Fresh Food Panel
is face down on a
non-scratch surface.
Bottom Right
Panel Bracket
21
Preparation for handles
1. Lay out the location of the custom handle on the back
of the Fresh Food Door panel and the Freezer Drawer
panel.
2. Counter-sink the handle screw locations on back of
the pane to avoid interference with the door frame.
Countersink 1/4" to maintain 1/2" minimum material
thickness.
3. Align the four tapered holes in one of the top panel
brackets with the four holes in the top of the Fresh Food
panel. Fasten the bracket using four screws.
4. Align the four tapered holes in one of the bottom panel
brackets with the four holes in the bottom of the Fresh
Food panel. Fasten the bracket using four screws.
Repeat with the Fresh Food panel.
5. Install the custom handle on the front side of the door
panel. A washer should be used in the countersink hole
on the back of the panel.
For RH Door panels (hinges on the right side when facing
refrigerator), follow these same procedures except using
the top right hand panel bracket and bottom right hand
panel bracket on the hinge side of the panel.
Top Left Panel
Bracket
Bottom Left
Panel Bracket