Step 12. Layout Decorative Door Panels - Monogram ZICS360NHLH Installation Instructions Manual

STEP 12 LAYOUT DECORATIVE DOOR PANELS - FLUSH INSTALLATION ONLY
Decorative wood panels must be cut to a thickness of
3/4". The dimensions of each panel can be determined by
referring to the specs provided with refrigerator. Panels
must be predrilled to prevent accidental splitting or
cracking of wood when attaching to door brackets in the
next step.
1. Cut Freezer Drawer and Fresh Food Door panels to
specified dimensions (as noted on page 11 under Design
Guide).
2. Lay the Freezer and Fresh Food panels face down on a
non-scratch surface.
3. Mark a vertical centerline on the backside of the Freezer
and Fresh Food panels.
4. Lay supplied Fresh Food Door panel TEMPLATE (attached
to side case of refrigerator) on the back of the Fresh
Food panel with the lettering face up. See illustration to
ensure proper template has been selected. Make sure
the notch at the top is on the side opposite the hinges
(since this is the BACK of the panel). Align the top, side,
and centerline of the template with the top, side and
centerline of the door. Tape the template to the panel
using masking tape to temporarily secure it in place.
The hinge in this example
is on the right hand side
so the notch is on the left
on the back of the panel.
5. Repeat previous step on the Freezer Drawer panel using
the Freezer Drawer panel template.
Installation Instructions
Template is aligned
with top of Fresh
Food panel.
Panel is face down
on a non-scratch
surface. You will be
drilling on the BACK
of the panel.
6. Using a 1/8" wood drill bit, drill pilot holes 1/4" deep
through only the top group of holes in the Fresh Food
Door panel template. Drill all four sets of holes into the
upper and lower corners of the Freezer Drawer panel.
7. Using a pencil, trace the outline of the notch out of the
template at the top corner of the Fresh Food door. This
mark will provide a guide for routing wood to provide
relief for door hinge at top of door panel.
8. Remove the tape from each panel. Slide the Fresh Food
door template to the bottom of the door panel aligning
the bottom, sides, and centerline of the panel with the
bottom, sides and centerline of the templates. Tape in
place.
9. Using a 1/8" wood drill bit, drill pilot holes into the door
panels 1/4" deep through only the bottom group of
holes in the Fresh Food Door panel template. Four
holes will be drilled into the bottom corners of each
door.
20