Jacking Up The Vehicle; Removing The Hood - Toro 07379 Operator's Manual

frame channel and install 2 clevis pins and lynch pins
(Figure 26).
2. On each side of the machine, secure the bed mounting
bracket to the frame bracket with the flange head bolt
and flange nut previously removed (Figure 25)

Jacking Up the Vehicle

DANGER
A vehicle on a jack may be unstable and slip off of
the jack, injuring anyone beneath it.
• Do not start the vehicle while the vehicle is on a
jack.
• Always remove the key from the switch before
getting off of the vehicle.
• Block the tires when the vehicle is on a jack.
•
Do not start the engine while the vehicle is on a jack,
because the engine vibration or wheel movement could
cause the vehicle to slip off of the jack.
•
Do not work under the vehicle without jack stands
supporting it. The vehicle could slip off a jack, injuring
any one beneath it.
•
When jacking up the front of the vehicle, always place a 2
x 4 block (or similar material) between the jack and the
vehicle frame.
•
The jacking point at the front of the vehicle is under the
front center frame support (Figure 27) and at the rear it is
under the axle (Figure 28).
Figure 27
1. Front jacking points
1. Rear jacking points

Removing the Hood

1. While grasping the hood in the headlight openings, lift
up on the hood to release the lower mounting tabs
from the frame slots (Figure 29).
1. Hood
2. Pivot the bottom of the hood upward until the top
mounting tabs can be pulled from the frame slots
(Figure 29).
3. Pivot the top of hood forward and unplug the wire
connectors from the head lights (Figure 29).
4. Remove the hood.
To install the hood, complete the following:
31
Figure 28
Figure 29