General International BS5205 Setup And Operation Manual page 7

(tables, saw horses, blocks, etc.) for any workpiece large enough to tip
when not held down to the work table.
8. DO NOT LEAVE THE WORK AREA UNTIL ALL MOVING PARTS
HAVE STOPPED.
Shut off the power to master switches. Childproof the workshop!
9. BEFORE STARTING,
be certain the motor, table, attachments and adjustment knobs are
secured.
10. NEVER TURN THE MACHINE ON
with the workpiece contacting the cutting surface. Workpiece may be
thrown and cause injury or damage.
11. PREVENT THE WORKPIECE
from contacting the blade before starting the tool. Loss of control of the
workpiece is dangerous.
12. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY
ADJUSTMENTS.
Changing attachments, making bit changes, adjustments or repairs or
accessories can be dangerous if the tool could accidentally start. Turn
off and unplug the drill press before moving it.
13. TURN THE MACHINE OFF,
disconnect the machine from the power source, when not in operation
and before leaving the machine. Clean the table/work area before
leaving the machine.
14. DO NOT LEAVE THE WORK AREA UNTIL ALL MOVING PARTS
HAVE STOPPED.
Shut off the power to master switches. Childproof the workshop!
15. TO FREE ANY JAMMED MATERIAL, TURN THE SWITCH OFF.
Unplug the tool. Wait for all moving parts to stop before removing the
jammed material.
16. SUPPORT THE WORKPIECE FIRMLY WITH A CLAMP,
vise, or work table when cutting. Hold the workpiece firmly. Loss of
control of the workpiece can result in injury.
17. PROPERLY SUPPORT LONG OR WIDE WORKPIECES.
If a workpiece overhangs the table so that it could fall or tip if not held,
clamp it to the table or provide auxiliary support(s). Loss of control of
the workpiece is dangerous.
18. SUPPORT ROUND WORK PROPERLY
Use V blocks to prevent it from rolling.
19. USE THE RECOMMENDED CUTTING SPEED
for the specific operation and workpiece material — check the label for
information
20. KEEP PULLEY COVER CLOSED
when not making belt adjustments.
21. USE ONLY ACCESSORIES DESIGNED FOR THIS TOOL
to avoid serious injury from thrown, broken parts or work pieces.
22. AVOID AWKWARD OPERATIONS AND HAND POSITIONS.
A sudden slip could cause a hand to move into the blade.
23. NEVER PERFORM LAYOUT, ASSEMBLY, OR SET-UP WORK ON
THE TABLE
/work area when the machine is running. A sudden slip could cause a
hand or hair to move into the blade Severe injury can result.
24. DO NOT GET DISTRACTED AND ALWAYS CONCENTRATE ON
WHAT YOU ARE DOING.
Use common sense. Never operate the machine when you are tired,
sick, or under the influence of alcohol, or other drugs.
25. LOCK THE SWITCH IN THE "OFF" POSITION TO PREVENT
UNAUTHORIZED USE.
Someone else might accidentally start the machine and cause injury to
themselves.
26. FAILURE TO FOLLOW OPERATING INSTRUCTIONS AND SAFETY
PRECAUTIONS IN THIS INSTRUCTION MANUAL CAN RESULT IN
SERIOUS INJURY.
Read the manual before starting or operating this unit.
141110
7